Where it is used
The material is intended for finishing treatments including levels Q2–Q4 according to the application. The base must be dry, dust-free and suitable for the chosen finish.
The published norm per millimeter layer allows a preliminary calculation. Actual amount is affected by base and thickness.
System and application
Joint treatment and overall skim coating are different steps in the surface finishing system.
Knauf jointing and finishing compounds ↗Application method
- Homogenize the mixture; dilution is done only according to the manufacturer's instructions.
- Apply and smooth by hand or with suitable equipment.
- Allow ventilation and drying before sanding and painting.
This is a brief guide. When performing, follow the data sheet, safety instructions and the specific system.
Limitations and application notes
The finishing layer does not replace the main filling of the joints. The consumption per linear meter of joint and the consumption per square meter of putty are not interchangeable.
Frequently asked questions
Can this material be replaced with another from the same group?
Replacement is assessed according to the basis, purpose and system. The exact data sheets are compared, not just the band name.
Is the specified consumption sufficient for an order?
The norm is a starting point under the specified conditions. For the project, the actual area or length, layers, cut and losses are specified; for wet mixtures, a trial application is made.
