Where it is used
Used for compatible joints and full-surface finishing. For HRAK edges, the initial joint treatment must be specified with a suitable joint filler.
The mixture was air dried. The time between coats depends on thickness, temperature and humidity.
System and application
Joint treatment and overall skim coating are different steps in the surface finishing system.
Knauf jointing and finishing compounds ↗Application method
- Check dry substrate and joint treatment.
- Mix and apply according to the system and method chosen.
- Wait for the layer to dry before further processing.
This is a brief guide. When performing, follow the data sheet, safety instructions and the specific system.
Limitations and application notes
The finishing layer does not replace the main filling of the joints. The consumption per linear meter of joint and the consumption per square meter of putty are not interchangeable.
Frequently asked questions
Can this material be replaced with another from the same group?
Replacement is assessed according to the basis, purpose and system. The exact data sheets are compared, not just the band name.
Is the specified consumption sufficient for an order?
The norm is a starting point under the specified conditions. For the project, the actual area or length, layers, cut and losses are specified; for wet mixtures, a trial application is made.
