Where it is used
Fugenfüller Leicht is used for jointing with tape on compatible board edges and in compatible systems. The Bulgarian product page specifies Kurt tape as the preferred solution.
Joint processing is an independent stage. The need for an overall fine render is determined by the paint, lighting and desired finish.
System and application
Joint treatment and overall skim coating are different steps in the surface finishing system.
Knauf jointing and finishing compounds ↗Application method
- Prepare the joint according to the type of edging.
- Lay the material and the provided reinforcing tape.
- Process the joints and screw heads; wait for the next layer to be ready.
This is a brief guide. When performing, follow the data sheet, safety instructions and the specific system.
Limitations and application notes
The finishing layer does not replace the main filling of the joints. The consumption per linear meter of joint and the consumption per square meter of putty are not interchangeable.
Frequently asked questions
Can this material be replaced with another from the same group?
Replacement is assessed according to the basis, purpose and system. The exact data sheets are compared, not just the band name.
Is the specified consumption sufficient for an order?
The norm is a starting point under the specified conditions. For the project, the actual area or length, layers, cut and losses are specified; for wet mixtures, a trial application is made.
